Tag: getenforce

  • RHEL6 – Display and Modify SELinux Modes

    There are three basic commands that you can use to display and modify SELinux modes. They are as follows

    • getenforce

    • setenforce

    • sestatus

    The first two are installed as part of the package, libselinux-utils. The sestatus is installed as part of policycoreutils.

    Setenforce will enable or disable SELinux temporarily. Use 0 to disable and 1 to enable as shown below.

    #setenforce 0

    #setenforce 1

    If you need need your change to be persistent across reboots edit /etc/selinux/config.

    # This file controls the state of SELinux on the system.
    # SELINUX= can take one of these three values:
    #       enforcing - SELinux security policy is enforced.
    #       permissive - SELinux prints warnings instead of enforcing.
    #       disabled - SELinux is fully disabled.
    SELINUX=enforcing
    # SELINUXTYPE= type of policy in use. Possible values are:
    #       targeted - Only targeted network daemons are protected.
    #       strict - Full SELinux protection.
    SELINUXTYPE=targeted

    Getenforce is used to query your SELinux Status as seen below

    [root@vpaquin01 selinux]# getenforce 
    Enforcing

    Sestatus give you the same information as getenforce but in a bit more detail

    [root@vpaquin01 selinux]# /usr/sbin/sestatus
    SELinux status:                 enabled
    SELinuxfs mount:                /selinux
    Current mode:                   enforcing
    Mode from config file:          enforcing
    Policy version:                 24
    Policy from config file:        targeted