Tag: grafana

  • Centos7/Rhel7 – Collectd Config for Libvirt, Carbon-Cache

    collectd-logo

    The following is the collectd config that I am running on my RHEL 7 kvm hypervisor. This is not meant to be an all inclusive config for collectd, rather I am looking to gather basic performance metrics on my hypervisors and VMs.

    Note that I have disabled selinux, as I am running these hypervisors in my lab. Do not do the same in your production environments.

    
    #setenforce 0
    

    I also edited /etc/selinux/config as shown below. Again, this is for non-prod/test envs. Do not disable in production

    
    # This file controls the state of SELinux on the system.
    # SELINUX= can take one of these three values:
    #     enforcing - SELinux security policy is enforced.
    #     permissive - SELinux prints warnings instead of enforcing.
    #     disabled - No SELinux policy is loaded.
    SELINUX=disabled
    # SELINUXTYPE= can take one of three two values:
    #     targeted - Targeted processes are protected,
    #     minimum - Modification of targeted policy. Only selected processes are protected. 
    #     mls - Multi Level Security protection.
    SELINUXTYPE=targeted 
    

    Also note that I have already configured the EPEL repo.. again, not production.

    EPEL repo installed via the command below

    
    rpm -ivh https://dl.fedoraproject.org/pub/epel/epel-release-latest-7.noarch.rpm
    

    First a couple of steps to get us up and running. We need to install packages

    
    # yum -y install collectd collectd-virt.x86_64 collectd-rrdtool.x86_64 collectd-sensors.x86_64 collectd-smart.x86_64 collectd-netlink.x86_64 collectd-ipmi.x86_64
    

    We also need to write our config.

    You can pull my config using the gist below

    We now need to enable and start collectd

    
    #systemctl enable collect
    #systemctl start collectd