So as I have stated before, I am still very new to Git. I know just enough to do a few basic tasks, but nothing much more advanced than that. Thankfully, the process of cloning a remote Git repository is actually rather simple once you know what you are doing. Forking a repo is just as easy. Again, once you know what you are doing. Below I am going to walk you through the steps in a very simple and easy to understand way.
how to
How to Add and Delete Persistant Routes in AIX
Wow, AIX does not like to make anything easy. Nor do they like to make things intuitive. Need to remove a route from AIX, well get ready to have one command to temporariliy remove a route and another command to remove the route for good. Same goes with adding a route. "Quit your bitching, and use Smitty", you say? Well smitty does not make anythign any easier, especially since the UI likes to show you fields that you does not necessarily need you to use. Oh, plus they let you type in them. Asking me for a netmask when adding a static route does not seem like a crazy request to me? But jokes on you, you were not supposed to type anything there.
HomeLab: Basic Syslog Configuration on Cisco Catalyst Devices
In my homelab setup I am dumping syslog on all my devices to my Linux desktop. Have not figure out what I am going to do with it yet, but I see myself either setting up Splunk or Greylog in the near future. Note, a while back I wrote a post on how to configure rsyslog on RHEL 6 - s0 if you are interested you can find that post here.
HomeLab: The Cisco 3560G
The Cisco Catalyst 3506G is a layer 3 switch which went end-of-life in 2009. For the home lab its a pretty nice switch to have due to its layer 3 support and gigabit speed. Mine is the model seen to the left, 24 gigabit ports and 4x1gb SFP uplinks. The Cisco Catalyst 3560 is … Continue reading HomeLab: The Cisco 3560G
RHEL6 – RTFM Apache Web Server
There is a lot to know and remember about configuring Apache as you may or may not have seen from the numerous posts I have written on the subject, and the reality is that no one is going to be able to memorize each and every settings, configuration, and directive. Sure you can bing it or google it , you can even alta-vista it, but only if you have internet access at the time, however there is always a chance that you might get some bad information. So why not refer to the official httpd documentation. You know RTFM and what not.
ProLiant System Management Homepage
The HP Systems management homepage is a web based utility for managing and monitoring Proliant Servers. It can be installed via the ProLiant Support Pack DVD (on linux its just an rpm). Once installed you can modify the default settings via the perl script, hpSMHSetup.pl located in /usr/local/hp. To access your server's homepage navigate to … Continue reading ProLiant System Management Homepage